How to Manage Pests

UC Pest Management Guidelines


Downy Mildew

Pathogen: Peronospora sparsa

(Reviewed 12/09, updated 12/09, pesticides updated 6/15)

In this Guideline:

Symptoms and Signs

Downy mildew initially causes a light green to yellow discoloration on the upper blackberry or olallieberry leaf surface that eventually progresses to red and purple. Mature lesions are often angular and restricted by veins. White to gray spore masses also appear on the opposite side of lesions on the leaf underside, but they may be sparse and difficult to see.

Primocanes systemically infected by downy mildew are often stunted and have red streaks on the side of the cane that faces the sun, with reddish colored terminal leaves. Downy mildew infected fruit (dry berry) is dull in luster, lacking in turgidity, and dries out rapidly. Early infection of green fruit induces premature reddening, shriveling, and hardening. Fruit infection later in the season causes shriveling, drying, and the fruit splitting into two parts. Downy mildew infected pedicels are dry and red.

Comments on the Disease

Downy mildew is most prevalent during wet weather at temperatures of 65°F (18°C). The pathogen overwinters as mycelium inside roots, crowns, and canes. Sporulation is usually found in dense foliage near the cane or at the base of the plant. Airborne spores are produced during cool, wet nights and are disseminated by wind. Symptoms develop within 10 to 11 days after infection.

Weed growth and dense canopies create humid environments that favor the development of the disease on suckers.


Use pathogen-free planting stocks. If possible, avoid planting in sites with a history of this disease. The use of macrotunnels is very limiting to downy mildew infestation, because of the near total lack of free moisture on the leaves and flowers of the plants.

Destroy alternate hosts, such as rose or wild blackberries, that are in close proximity to a planting. Once the planting is established, remove suckers and weeds to reduce humidity at the base of the plant. Remove and destroy old fruiting canes after harvest. Reducing moisture in the hedgerow by pruning can be key in managing downy mildew.

Organically Acceptable Methods

The use of clean planting stock, careful site selection, proper pruning, maintenance of a dry hedgerow, and some copper sprays are acceptable for use on organically certified produce.

Treatment Decisions

Fungicide sprays may be applied in spring to protect blackberry foliage, flowers, and developing berries from infection.

Common name Amount per acre R.E.I.‡ P.H.I.‡
(Example trade name)   (hours) (days)

Calculate impact of pesticide on air quality
Bee precaution pesticide ratings
When choosing a pesticide, consider its usefulness in an IPM program by reviewing the pesticide's properties, efficacy, application timing, and information relating to resistance management, honey bees (PDF), and environmental impact. Not all registered pesticides are listed. Always read the label of the product being used.
  (Aliette WDG) 5 lb 12 60
  COMMENTS: Do not tank mix with copper compounds, surfactants, or foliar fertilizers.
  (Fosphite) Label rates 4 0
  COMMENTS: Do not tank mix with copper compounds, surfactants, or foliar fertilizers. Allow 20 days before applying to a copper-treated crop.
C. COPPER# Label rates 24 0
  MODE-OF-ACTION GROUP NAME (NUMBER1): Multi-site contact (M1)
  COMMENTS: For organically certified produce, check with your certifier for acceptable copper formulations.
Restricted entry interval (R.E.I.) is the number of hours (unless otherwise noted) from treatment until the treated area can be safely entered without protective clothing. Preharvest interval (P.H.I.) is the number of days from treatment to harvest. In some cases the REI exceeds the PHI. The longer of two intervals is the minimum time that must elapse before harvest.
# Acceptable for use on organically grown produce.
1 Group numbers are assigned by the Fungicide Resistance Action Committee (FRAC) according to different modes of actions (for more information, see Fungicides with a different group number are suitable to alternate in a resistance management program. In California, make no more than one application of fungicides with mode of action Group numbers 1, 4, 9, 11, or 17 before rotating to a fungicide with a different mode of action Group number; for fungicides with other Group numbers, make no more than two consecutive applications before rotating to a fungicide with a different mode of action Group number.



[UC Peer Reviewed]

UC IPM Pest Management Guidelines: Caneberries
UC ANR Publication 3437


  • S. T. Koike, UC Cooperative Extension, Monterey County
  • M. P. Bolda, UC Cooperative Extension, Santa Cruz County
  • W. D. Gubler, Plant Pathology, UC Davis
  • L. J. Bettiga, UC Cooperative Extension, Monterey County
Acknowledgment for contributions to Diseases:
  • E. J. Perry, UC Cooperative Extension, Stanislaus County

Top of page

Statewide IPM Program, Agriculture and Natural Resources, University of California
All contents copyright © 2016 The Regents of the University of California. All rights reserved.

For noncommercial purposes only, any Web site may link directly to this page. FOR ALL OTHER USES or more information, read Legal Notices. Unfortunately, we cannot provide individual solutions to specific pest problems. See our Home page, or in the U.S., contact your local Cooperative Extension office for assistance.

Agriculture and Natural Resources, University of California

Accessibility   /PMG/r71100511.html revised: June 21, 2016. Contact webmaster.